SavvyGrow 6/8/14 Hydroponic Growing System

How To Set Up


1. Insert elbow connectors (H) into the top and bottom holes on the water reservoir.
SavvyGrow 6/8/14 Hydroponic Growing System

2. Insert screw nuts (G) into the top and bottom elbow connectors from inside the water reservoir.
SavvyGrow 6/8/14 Hydroponic Growing System

3. Use the included wrench to tighten the screw nuts (G) to elbow connectors (H).
SavvyGrow 6/8/14 Hydroponic Growing System

4. Insert water level tube (I) into the top and bottom elbow connectors.
NOTE: Be sure to push the tube all the way into the elbow connector for a secure fit.
SavvyGrow 6/8/14 Hydroponic Growing System

5. Cut 2 4-5 inch pieces from the micro tubing (E), set aside.
SavvyGrow 6/8/14 Hydroponic Growing System

6. Cut the remaining tubing in half. Insert one end of each piece into each airstone (F).

7. Insert the airstones, with the tube pointing up, into the small holes on the top of the water reservoir lid (A), as shown.
SavvyGrow 6/8/14 Hydroponic Growing System

8. Connect the short pieces you cut earlier into the air pump (D), and attach the inline check valves (C) to the other end, as shown.
Note: The inline check valve (C) prevents water from flooding the air pump in case of power outage. The check valve will have a label or arrow indicating the direction of air flow. The word “IN” should be on the side of the air pump.
SavvyGrow 6/8/14 Hydroponic Growing System

9. Slip the free ends of the tubes leading from the airstones over the other side of the check valves.

SavvyGrow 6/8/14 Hydroponic Growing System

10. Insert a net cup into one of the empty holes in the reservoir lid, and fill the reservoir up to the bottom of the cup. You can check the water level by looking at the water level tube (I).

11. Place your baby plant into the net cup and fill it up with the ceramsites (K) to keep it firmly in place. Place the cup into a hole on the lid.

12. Add a hydroponic fertilizer, either a powder-base such as General Hydroponics MaxiGrow (https://goo.gl/EcigD5) or a pre-mixed, water-based such as General Hydroponics FloraGrow Fertilizer (https://goo.gl/ZYvYwZ).

13. Check to make sure everything is tightly connected and there are no leaks, and turn on power to the pump.

Tips, Tricks, And Hacks

  • The pH level of the water in the reservoir is important to keep plants thriving!
  • The water can become too acidic or too alkaline as it’s used or evaporates. To avoid that, you should keep the water level at around 2 inches (50mm) below the bottom of your net pots. Keeping the reservoir topped off stabilizes pH levels to help your plants to thrive.
  • For flowers: Another easy tip for maintaining ideal water conditions is to change the water every couple of weeks while the plants aren’t budding or blooming, and once per week while flowering.
  • If you would like your air pump to be quieter, place it on a solid, thick surface and not directly on the floor; this will reduce vibration and quieten things down quite a bit.
  • If you use a grow tent and an exhaust fan and your exhaust fan is too loud you can try hanging it from inside the tent rather than setting it on top, this will significantly reduce noise levels.
  • If you want to prevent root rot due to the presence of fungus-like organisms such as Pythium, you can load the reservoir with a beneficial bacteria such as the root supplement Botanicare Hydroguard which is super-effective at preventing root rot.

Follow us on all our social media accounts:
Facebook
Pinterest
Instagram
Twitter
Youtube